Newland FM200 Guide de l'utilisateur télécharger pdf (Page 17)

Getting Start

nlscan.com

Page 11

Programming Outline

Command Programming

The Programming Command (Pro CMD) pairs a unique Programming Code. Sending commands to the Imager

is identical with Code Programming. A full command is formed by [Start Symbol "nls" + Pro CMD = Parameters].

There are 4 ways to program a command:

"nls" + Pro CMD1.

E.g. [nls0100060], set RS232 transmit Baud Rate to 38400bps

"nls" + Pro CMD = Decimal Parameter2.

It is used to define

parameter, such as Min Message Length.

E.g. [nls0312040=10], select Sensor Mode Sensitivity to be 10

"nls" + Pro CMD = Hex Parameter3.

It is used to program Prefix, Suffix, Stop Bits, CodeID, Message Length, and Message Intersection.

E.g. [nls0310000=0x0d0a], program Suffix to be CR/LF

"nls" + Pro CMD = "Parameter"4.

Letters, digits and characters can be embraced by quotation mark as parameter.

E.g. [n

ls0300000="AUTO-ID"], program Prefix to be AUTO-ID

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 114 115

Pas de commentaire

Newland FM200 Guide de l'utilisateur Page 17